Professional lighting and effects equipment. Hand made in the USA.
Created 30, April, 1997
Copyright W. McIntire Ent.
Explore this page or click on any of the items below or
use the items in the left panel to go somewhere else.
Lighting F/X Generators |
Inline AC Dimmers
DC Products |
Wireless Cue Lights
Architectural Products
Prop F/X |
Misc. Items
Sales Policy |
Price List
MISCELLANEOUS GADGETS:
AUTO POWER DISCONNECT
Expensive electronic equipment needs more than surge suppressors and circuit breakers to insure against power line damage. When power fails, especially over a wide geographic area, there is a dangerous surge when that power is restored. This will often exceed the limits of the common surge suppressor. This device DISCONNECTS the equipment upon power failure, isolating the equipment from the power source until the reset button is pressed. Has line and load power indicators, 20 amp fuse. Click here to view the INSTRUCTIONS.2K LIGHT ORGAN
A Single channel "color organ". Use as many of these single channel units as needed to add light response to any audio signal. 10K ohm audio input will accept sound from almost any source, tape, radio, PA system, etc. An input level control adjusts incoming sound level. The built-in bandpass filter allows adjustment of BOTH low frequency cutoff point AND high frequency cutoff point giving complete control over the desired band of frequencies that will actuate the connected lamps, up to 2,000 watts! Several units tuned differently create quite a display! Interface output DIRECTLY DRIVES OUR DIMMERS for as much lighting power as you want! Add this to your musical instruments and you have synchronized eye candy on stage! Click here to view the bifold INSTRUCTION SHEET.
PHOTOFLASH SIMULATION INTERFACE
Shutter "open" signal from camera insures that when the unit is triggered the camera shutter will be open and the flash will be recorded on film every time. Click here to view the INSTRUCTIONS.BURNOUT ALARM
Lamp burnout during stop motion animation can be expensive if the burnout is not detected quickly. The Burnout Alarm senses if a lamp circuit opens and alerts you with a loud audible alarm and high intensity red LED lamp. A remote output can indicate the burnout on a distant annunciator or send the alarm to the animation rig to prevent further operation until the problem is corrected. The sound can be switched off if desired. Many other uses. 2,000 watt max load. Click here to view the INSTRUCTIONS.
